精選產品
- 木材乾燥設備(電氣式) (1)
- 單立軸機 (1)
- 夾頭 (1)
- 自動化機械之週邊設備 (1)
聯絡資訊
The North Dongfang Road,Mazhai Industrial Park,Zhengzhou City,Henan Province,China
電話：86-371-60395600
傳真：86-371-67681159
Autoclave Aerated Concrete (AAC)
產品型號：Autoclave Aerated Concrete (AAC)
產品特色
AAC Plant, Autoclave Aerated Concrete (AAC) Production LineKeywords:AAC Machine,AAC Plant,AAC Equipment,AAC Production,AAC Machinery
Annual out put 50,000-300,000m3 Production Technique
1. Product Principle1) Technology Orientation
Production and application of aerated concrete has a history more than 40 years in China. Viewing from technology point, high quality products can use 3mm special sand slurry technology to meet the construction requests and 50% energy saving goals. (When mortar joint is less than 3mm, take thermal conductivity coefficient of wall as 1; when mortar joint is more than 3mm, take thermal conductivity coefficient of wall as 1.5). Based on the history of the aerated concrete development, only high quality products can bring a prosperous market. Thus, the technology orientation of this scheme is high-class products according to China Standard GB11968-2006.
2) Production Capacity
The product is aerated concrete block and the output is 150,000m3 per year. The first phase can be equipped according to 100,000m3 per year. There is a reservation of plate in consideration of user's need.
3) Product Specification
Products conform to requirement of 04~07 grade blocks stated in GB11968-2006. General Specifications of Aerated Concrete Blocks
Process Flow Technological process:
1. The raw materials store in the material storehouse (or stores the pot) after dealing with reserve such as lime, cement, gypsum, sand (or fly ash)
2. Aluminum powder or aluminum lotion is through dealing with the reserve material for use
3. Raw materials measure according to certain matching by electron balance measure, aluminum powder, water put into aluminum powder mixer is it is it suspend the liquid to make to mix after measuring
4. The batching water (cold water or hot water pitcher hot water) is measured by the electronic water balance
5. Put into and pour among the mixers in certain order after, raw materials, aluminum powder suspend the liquid is measured, pour and enter the mould after mixing evenly (panel should be put network slice of reinforcing bar in advance in the mould)
6. Quiet to is it raise in advance to park through certain temperature and time, is it transport to the cutting machine to hang from upset hoist upset 90 after the base body reaches certain intensity, the drawing of patterns is cut
a. The base body carries on the side and cuts and mills the trough vertically at first b. Then carry on the vertical level to cut c. Cut horizontally finally d. Cut good base body, raises to cauldron car go on one yard of shelves organize into groups to steam to transport to hang to drive a vehicle to load
7. Raise products well, produce after the cauldron breaking the board off with the fingers and thumb by the board breaking off with the fingers and thumb machine to steam
精選產品
