產品規格

PTO Shaft to fit Single Auger Twin Auger and the Total Mix
PTO shaft used for Jaylor Vertical Mixers TMR

The device transmits motion in a single direction as the tractor drives the implement. In the stop phase, the tractor PTO shaft is disengaged, and the machine is moved. The transmission is cut off.

This device assists in operating machinery that has high-speed inertia due to when the stop phase is in place this tractor's PTO is removed from the machine being driven.

Original Equipment is listed on the left as Size 6, or 8 copy of BYP. )Based on HP

at 60 HP or lower = CAT4 = Size 6. ******* greater than 60 HP = CAT5 = Size 8.

Jaylor provides Constant Velocity shafts or standard PTO

We also supply all components for the feed mixer.

PARTS OF THE PTO SHAFT

PTO Shaft for Jaylor Vertical TMR Feed Mixers
It's crucial to understand the dimensions, measurement horsepower, dimensions, and other PTO shaft components in order to select the correct PTO shaft that will fit your equipment. Although the U-joints and yokes are essential for their function however, the safety chains as well as the shield are the most important components that make up the PTO shaft, which will help ensure your safety during operation.

Internal Yoke: There are two of them, situated on both sides of the PTO shaft, namely the implement and the tractor. The welded end is attached to the drive side.
Universal Joint- There are two at each end of the PTO shaft.
External Yoke - There are two on both sides of the PTO shaft. It is a "Y" design to connect to the U-joint as well as an opening for females.
Safety Chains - The chains anchor the PTO shaft onto the machine and also the tractor.
Safety ShieldCones are located at both ends.
Size is the most important aspect of the PTO shaft
Whatever task you'll use the PTO shaft for it is essential to are using the right dimension. The manufacturer will provide length recommendations to help to get an idea. When measuring the length of a PTO shaft, you can use the tape measure and take measurements from the outside of each yoke in order to get the length closed. The size of the series should be in line with the horsepower that your tractor is equipped with. Two different speeds are employed typically when using tractor PTO shafts, 540 (type one) and 1000 (type three) RPM.