精選產品
聯絡資訊
Room 301-7A,3/F HongKong Trade Center 161-167 Des Voeux road, Central,HK
電話：86-852-30763082
傳真：86-852-30697029
reinforced reaction injection molding Reaction Injection Molding
產品型號：reinforced reaction injection molding Reaction Inj
產品特色
reinforced reaction injection molding Reaction Injection Molding
產品規格
| The characteristic of RIM process is the material flow rate is very high .Then stoste’s viscosity can not be very high .Such as the viscosity of polyurethane mixture is about 0.1 Pa s.and flow rate control at 600 g/s in mold falling . Polyurethane two-component mixture have very high reactivity after injected in the mold ,so it complete curing in ten more minutes .But plastic’s conductivity is not good , so most heat can not release from a large chemical reaction condition , so that the outside temperature are higher than inside, so the curing development is from inside to outside . http://www.youdeprototypechina.com |
精選產品
